OMD35 Integrated
Stepper Drive & Controller
The OMD35 is an integrated stepper motor drive and motion controller in one. Through a simple RS485 communications interface you can control a stepper motor with exceptional control and accuracy. Selectable acceleration ramps at velocities up to 2M steps/sec. Selectable microstep resolution from full up to 1/256 microstep. Its small design is compatible to mount on the back of a stepper motor, and includes a hole in the center so the shaft of a linear actuator motor can pass through when mounted on the motor.
Features:
-
Advanced motion control capabilities
-
Simple communications through RS485 interface
-
Communication speed = 115.2K Baud
-
Velocity = 0 to 2M steps per second
-
Microstep resolutions include full, 1/2, 1/4, 1/8, 1/16, 1/64, 1/128, 1/256
-
Exceptional accuracy: +/- 0% position, 2% velocity (full-steps)
-
Single supply voltage +10V to +50V
-
0 to 7 amp phase current for high torque motors
-
Center pass-through hole for linear actuator stepper motors
-
No heat-sink required for typical current
-
Matches the NEMA 23 dimension for direct motor mounting
-
Screw-terminal connector plugs for convenient wiring
-
LED indicator for status
-
Positive and negative limit inputs as well as Home input
(If you're having difficulty, please try
switching to a different Internet browser.)